Posted: Sun Apr 18, 2010 9:36 am Post subject: 06 Interceptor, Bad Noid?
Hi All,
Well, I'm wondering if I have a bad noid. Everything was working fine, I had just replaced my LPR with a AKA LPR. While breaking in the LPR, the pressure went up to over 150. I degased it, and put the stock one back in. It still went up to over 150. Tried turning it down and got it back to 100. Now the RAM will not move forward when pulling the trigger. It seems like air isn't getting to the back of the RAM. I have tried it with eyes bypassed and sim mode, but no go. I removed the RAM from the noid and put air to it, and air came out the bottom of the RAM, so I know air is getting to the noid. Trigger pulls are being registered as I can change modes. I also replaced the battery. There are no air leaks. Dwell is set to stock (I also turned it up to 15). The noid is clicking and it seems like a little bit of air is venting out of either the noid or RAM housing, when I pull the trigger.
Any ideas? Thanks.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in
